How To Change Zero Water Filter?

How To Change Zero Water Filter?

The zero water filter is a contaminant filter that eliminates all the impurities and other harmful particles from the drinking water. This helps in producing clean and healthy drinking water. All these filters are designed to fit easily into your pitcher thus maintaining its functionality.

Steps for changing zero water filter:

1] The first step is to turn off your main supply by cutting it with the help of a valve which you can find at the backside of the zero water filter machine, under the sink area. This will prevent any serious injury if anything happens during installation. You should be careful while doing this as shutting down your hot or cold tap could release some residual pressure that might cause damage by spraying everywhere.

2] After turning off your water supply, you should then turn on your faucet to release any residual water pressure that might have been trapped inside the system.

3] Now remove any excess water from the tube by using a clean cloth or towel. Some pitchers are designed to catch this excess water but if yours doesn’t, make sure you drain it somewhere else other than your sink because it’s pretty messy. You can use a disposable tray for catching the dirty water as well.

4] The next step is to turn off your cold water tap by rotating it until it gets completely shut down and then attaching one end of the Teflon tape into the threading of that tap and winding it around about 3x starting right at the base where the tap enters the water supply pipe. This will make sure that you can open your cold water tap without any leaks at all.

5] After winding the Teflon tape correctly around the thread, re-attach this tap into its original position and then turn it back on again to allow some freshwater into your system before you close it off with an adjustable wrench.

6] Now you should unwind another 3 turns of the Teflon tape onto your faucet component, right after where it meets up with the mainline coming in from the street or municipal source.

7] Afterwards, attach one end of a rubber ring onto each side of your filter’s mounting assembly/housing using your fingers only so as not to tear them. When attaching these rings, make sure that the rubber doesn’t get pushed up into the top area of your filter, or else it will not seal properly under pressure.

8] Now attach the mounting assembly to the faucet with an adjustable wrench by placing it directly over where you have just attached those rings. Make sure that you tighten down all three taps tightly so that any leakage is completely obstructed and no water can escape from your system at all.

9] After doing this, turn on both taps again to flush out any residual particles from the new zero water replacement filter system before turning them off once more with a valve near your sink’s drain area.

10]Now re-attach your clean white supply line back onto your new filter system to make sure that it has a nice tight fit. You can do this by compressing it down directly over the mounting assembly/housing of the filter with another adjustable wrench.

11] Now, turn on both taps again one at a time to re-introduce water into your drinking faucet component to purge any additional air or particles that may have entered during initial installation or when removing parts for replacement.

12] After purging all the components, you should then install the new zero water replacement filter system back under your sink before turning on your main supply line again to flush out any residual bits and pieces of Teflon tape left behind before finalizing its installation once and for all.

13] Lastly, you should then turn on your water purification system tap to allow it to run free for approximately 5 minutes before using any of the filtered water. This is so that any excess particles or chemicals in your line can be flushed out well enough, after which point you can sit back and enjoy fresh-tasting bottled quality water at the touch of a button.

Leave a Comment